Mobileye Proprietary and Confidential
support@mobileye.com
road, weather and other conditions can adversely affect the Mobileye 6
recognition and response capabilities.
Any conditions that form partial or full blockage of the
reduced or non-functionality of Mobileye 6 performance. Always ensure clear
camera view.
1.3 Installation and Safety Instructions
Mobileye 6 installation must be carried out by an Authorized Mobileye 6 Dealer or
Installer.
The Mobileye 6 system should not be transferred between vehicles, other than by an
Authorized Mobileye 6 Dealer or Installer.
The Mobileye 6 should only be operated with 12VDC~24VDC power.
Do not cover or obstruct the Camera Unit or Mobileye 6 Display and Control Unit.
Only proper tools are to be used.
Only L.E.D voltage tester or Digital Multi Meter should be used.
The use of light bulb voltage tester is prohibited.
Pay attention to unusual color cables for example: Yellow cable isolation belongs to
air bags; two twisted wires usually belong to different sensors (digital).
Before disconnecting the battery or the radio connectors make sure to have the
radio code.
Do not disconnect any plug or connector in the vehicle when the ignition switch is
turned on.
NOTE:
- Mobileye 6
®
installation is possible only on CAN-bus supported vehicles.
- Minimum CAN-bus signals required for Mobileye 6 installation:
- Speed
- Mobileye 6 installation on non CAN-bus vehicles is possible only using the Mobileye E-box
add-on
To Next Page
Loading...
