Mobileye Proprietary and Confidential
support@mobileye.com
8 Appendix D
8.1 Verifying the Camera Angle
In order to verify the correct Camera angle we will refer to the calibration results
which are displayed after the TAC Calculation process is completed.
For example:
If after the Close/Far TAC calculation the F.O.E- Y value is 70, we will prefer to
change the Camera angle so that the F.O.E- Y value will be in a more desirable range
(between 0 to 50). In order to decrease this value, we should decrease the Camera
angle degree
A table with the recommended F.O.E- Y value according to different camera highest
(for best system performance) can be found below. Note this is only a
recommendation and values can vary by a value of ±10
To Next Page
Loading...
