52
D26 Camera Manual: Installation
2.5.2 Procedure
•
Remove the camera outer shell: Remove all four Allen screws
using the supplied Allen wrench and li o the outer shell.
• Remove the standard dome: Unscrew the dome from the
housing (counter-clockwise). Package and store the stan
-
dard dome for possible use at a later time.
•
Aim and adjust the lens: When mounting the camera for the rst time, please proceed
to Section 3.3.1, «Aiming and Adjusting the Lens».
•
Mount the reinforced dome of the Vandalism Set. Tighten it
in a clockwise direction using a so cotton cloth. If neces-
sary, clean the dome with a cotton cloth before installing it.
To Next Page
Loading...
