Mocom B CLASSIC - Page 57

55
EN
TECHNICAL MANUAL - B CLASSIC / B FUTURA / S CLASSIC
SERVICE MENU
SERVICE MENU – USER MANAGEMENT
SQ30
Selecting USER MANAGEMENT displays the user list management
screen, which is normally used by ofce personnel.
When you operate from menu SERVICE/USER MANAGEMENT, the
system will request no password to access the different users, including
the administrator.
You can make changes, delete or add users, change authorizations.
WARNING
Conrming any changes will delete the previous conguration settings.
SERVICE MENU – NETWORK CONFIGURATION
SQ31
The NETWORK CONFIGURATION menu is not active on Classic
versions, which have no Ethernet port.
SERVICE MENU – REF INPUT
SQ32
The REF INPUT function lets you enter the product code specic to each
individual model.
This code is stored at the factory and needs only be input after the
electronic card has been replaced. The procedure is outlined below.
From the SERVICE MENU, select REF INPUT and:
- Insert a USB memory with the original FW version or a later version
- Ensure that the USB memory is sensed and this is conrmed by two
beeps
- Press OK to conrm; this will display the list of product codes from the
same series (Futura or Classic).
- The proper code is reported on the ID plate on the rear panel
- Select the proper code
- Press OK to conrm