MAINTENANCE
Mandatory, routine or scheduled maintenance should not be required for the M1000 Mag Meter electronics or flow tube after
proper installation. However, some occurrences may require you to perform the following:
• Flow tube and electrode cleaning
• General cleaning
• Circuit board replacement
WARNING
DO NOT CLEAN COMPONENTS INSIDE THE AMPLIFIER OR JUNCTION BOX.
NE NETTOYEZ PAS LES COMPOSANTES À L'INTÉRIEUR DE L'AMPLIFICATEUR OU DE LA BOÎTE DE JONCTION.
Cleaning the Flow Tube and Electrode
At times flow tube, electrodes, amplifier/junction box housings and the amplifier window may need periodic cleaning,
depending on process fluid properties, fluid flow rate and surrounding environment.
Clean the flow tube and electrodes by following the material handling and cleaning procedures documented in the Material
Safety Data Sheet (MSDS) guidelines for the products(s) that were in contact with the flow tube and electrodes.
Should flow tube and/or electrode cleaning become necessary:
1. Disconnect detector from pipeline.
2. Clean electrodes according to MSDS guidelines.
3. Reconnect detector to pipeline.
General Cleaning
Switch off all units and isolate from mains before cleaning.
Clean using a damp cloth. Do no use liquid or aerosol cleaners.
Maintenance
Page 35 March 2020 MAG-UM-00379-EN-07
To Next Page
Loading...