EasyManua.ls Logo

ModMAG M1000 - Safety Precautions and Instructions; Basic Precautions; Installation Guidelines; Power Connection Safety

ModMAG M1000
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY PRECAUTIONS AND INSTRUCTIONS
Some procedures in this manual require special safety considerations. In such cases, the text is emphasized with the
following symbols:
Symbol Explanation
Indicates a hazardous situation, which, if not avoided, will result in death or serious personal injury.
WARNING
Indicates a hazardous situation, which, if not avoided, could result in death or serious personal injury.
Indicates a hazardous situation, which , if not avoided, could result in minor or moderate personal
injury or damage to property.
IF THE EQUIPMENT IS USED IN A MANNER NOT SPECIFIED BY THE MANUFACTURER, THE PROTECTION PROVIDED BY
THE EQUIPMENT MAY BE IMPAIRED.
ATTENTION
UTILISER L'ÉQUIPEMENT DE MANIÈRE NON SPÉCIFIÉE PAR LE FABRICANT POURRAIT DIMINUER LA PROTECTION
ASSURÉE PAR L'ÉQUIPEMENT.
Basic Precautions
Before installing or using this product, please read this instruction manual thoroughly. Only qualified personnel should install
and/or repair this product. If a fault appears, contact your distributor.
Installation
Do not place any unit on an unstable surface that may allow it to fall.
Never place the units above a radiator or heating unit.
Route all cabling away from potential hazards.
Isolate from the mains before removing any covers.
Power Connection
Use only the type of power source suitable for electronic equipment. If in doubt, contact your distributor. Make sure that any
power cables are of a sufficiently high current rating. All units must be earthed to eliminate the risk of electric shock. Failure to
properly earth a unit may cause damage to that unit or data stored within it.
Protection Class
The device has protection class IP 67 and needs to be protected against dripping water, oils and other liquids.
Setup and Operation
Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in
damage, incorrect operation or loss of data.
Safety Precautions and Instructions
Page 5 March 2020 MAG-UM-00379-EN-07

Table of Contents