SECTION TWO – WIRING AND INSTALLATION
DS2000 USER’S MANUAL (rev.C)
2.16
• WIRING NOTES FOR J6, J7, J9 CONNECTORS (SIZE C)
The relevant contacts (Molex type 42815-0031) are supplied together with J6, J7, and J9
mating connectors for C size DS2000 drives. These contacts are sized for an 8 AWG (8.4
mm2) cable with a 10 mm wire stripping. It is recommended the use of a Molex crimping
tool type 63814-0000, or Molex type 63811-1500, or equivalent. The crimping does not
affect the insulating plastic tubing. As an alternative it is possible to sold the contacts,
taking care of folding the contact wings.
After the crimping (or soldering), the contact must be inserted into the Mating connector
following the proper direction and must be kept in position by the TPA (Terminal Position
Assurance) jumper, according to Fig. 2.7.
Fig. 2.7 – Fixing Molex connectors
To Next Page
Loading...
