7
SETUP AND CONNECTIONS
Power Supply
Amplifier Or Headphones
power supply will operate with a power
source from 100 to 240 Volts AC, 50/60Hz.
Plug the other end of the included power adapter into an AC outlet.
NOTE: Your Mother-32 is an analog instrument and should be allowed 10-15 minutes to warm up before
use. In cases where it has been left in a cold car overnight, for example, it may take as long as 25 minutes
before oscillator tuning has stabilized. Do not operate the Mother-32 in direct sunlight.
If you are using a 5-pin MIDI cable for external control or sync, connect the MIDI OUT of your MIDI controller
to the MIDI IN on your Mother-32. By default, the Mother-32 is set to receive MIDI data on MIDI Channel 1.
AUDIO OUT
With the Master VOLUME control turned all the way down, plug one end of a 1/4” instrument cable into
the Mother-32’s AUDIO OUT jack on the rear panel. Then plug the other end into an amplied speaker
or mixing console input.
NOTE: You can also connect a pair of headphones to this jack to monitor the output.
Set the Panel controls to the following default settings:
Adjust the level by slowly turning the master VOLUME control clockwise while playing the keyboard.
POWER
Plug the included power adapter into
the 12VDC power jack on the back of
your Mother-32. The Mother-32’s universal
7.b
To Next Page
Loading...
Need help?
General
