27
INITIALIZING A PATTERN
Press (SHIFT)+RESET+PATTERN to initialize
the current pattern. This does not affect any
data stored in memory, but it will discard any
unsaved changes to a pattern.
CURRENT BANK AND PATTERN LOCATION
To check the bank of a
pattern currently in use, press
(SHIFT)+(BANK). One of eight
green Octave/Location LEDs will
be lit showing the current bank.
To check the location of a pattern currently
in use, press PATTERN. One of eight green
Octave/Location LEDs will be lit showing
the active pattern in the current bank.
NOTE: There is always one active pattern
when the Mother-32 is in normal operation.
TUTORIAL - CREATING A PATTERN IN STEP MODE
This is a tutorial that will walk you through the sequencing capabilities of your Mother-32 in Step mode.
Before starting, disconnect any patch cables, set all controls to the default position found on Page 7, and
ensure the current pattern is initialized by pressing (SHIFT)+RESET+PATTERN.
NOTE: In Step mode the 13-note Keyboard and LEFT/RIGHT arrows have different functions.
ENTER STEP MODE
Press (SHIFT)+(STEP). Octave/Location LED 1 is lit yellow
and there is no red Octave/Location LED indicating the
current octave setting. Step LED 1 is lit solid red.
SET THE TEMPO
Use the TEMPO control to set the desired tempo. Then
press RUN/STOP. A repeating note will be heard and Step
LED 1 will ash at the selected tempo.
++
+
+ =
Indicates Current Bank
(Green LED)
=
Indicates Current Pattern
(Green LED)
To Next Page
Loading...
