Moog Mother-32 - Play a Pattern; Run the Pattern; Pause a Pattern; Swing

23
PLAY A PATTERN
RUN THE PATTERN
Adjust the TEMPO control to the speed you want,
and press RUN/STOP.
The Sequencer will advance through each step in the
pattern. When it reaches the end, it loops around to
Step 1. The current step being played is indicated by
the corresponding Step LED being lit.
PAUSE A PATTERN
To pause a pattern at the last step played, press RUN/STOP. Pressing
RUN/STOP again will resume playback from the next step in the pattern.
RETURNING A PATTERN TO STEP ONE
To return a pattern to Step 1 at any time, simply press RESET.
HOLD A NOTE
Press HOLD during sequencer playback to pause the advance of a pattern. The
current step will be repeated at the current tempo for as long as this button is held.
SWING
While holding (SHIFT), rotate the TEMPO (SWING)
control to add a Swing value to a current pattern.
The range is from -100% to 100%.
When SWING is set to a value between -100% and 0, it
will move the off-beats earlier in time. At -100% swing,
only the off-beats will play. When SWING is set to a value
between 0 and 100%, it will move the on-beats later in time.
At 100% swing, only the on-beats will play. When SWING is set to 0 (center position), no Swing is
applied and all notes are played with equal timing.
NOTE: The Swing amount is stored per pattern.
+