39
PATCHBAY INPUTS AND OUTPUTS
EXTERNAL AUDIO INPUT
EXTERNAL AUDIO INPUT
This is a unity gain input that allows other sound sources to be processed
by Mother-32’s onboard Filter. Because this is a unity gain input designed to
Eurorack level standards, an external audio source applied to this input should
be 10V peak to peak. Signals lower than this (an MP3 player for instance) will
need to be amplied prior to being input to the EXT. AUDIO jack for proper
volume performance levels.
NOTE: When a cable is plugged into this jack, it overrides the normalization of
noise to the clockwise position of Mother-32’s main mixer. This means that the
MIX control becomes a level balancing control for the onboard oscillator and
any sound source plugged into the EXT. AUDIO jack.
MIX CONTROL VOLTAGE INPUT
MIX CV INPUT
This input is summed with the MIX panel control. With the MIX control at center
position, a -5V to +5V CV applied to this input will crossfade between the
selected VCO waveform and the EXT. AUDIO input (normalled to White Noise).
VOLTAGE CONTROLLED AMPLIFIER
VCA CV INPUT
This input allows a control voltage to be applied to Mother-32’s output VCA.
Patching an LFO to this input will allow you to create Tremolo effects (0 to +8V
in EG mode and +/-5V in ON mode, summed with signals from ON/EG switch).
VCA OUPUT
This is the output from the VCA after the Volume attenuator (+/-5V, typical).
To Next Page
Loading...
