Moog Mother-32 - KB Mode Panel Functions (continued); Set End Step | KB Mode; Step Mode Panel Functions; Pattern Page Select | Step Mode

36
SEQUENCER PANEL FUNCTION QUICK REFERENCE (continued)
KB MODE PANEL FUNCTIONS (continued)
SET END STEP | KB MODE
Press (SHIFT)+SET END.
If the desired end step is
on a different page, press
(SHIFT)+Page button 1-8,
9-16, 17-24 or 25-32. To
specify the last step in
the current pattern, press
(SHIFT)+Step button 1-8.
If the new end step is after the previous end step, the notes are lled as follows: If the steps after the
previous end step have never been edited and stored in memory, or if the pattern was initialized, then
all steps get the default note value (-1V) and gate length (50%). If the steps were previously edited,
then they are restored.
STEP MODE PANEL FUNCTIONS
PATTERN PAGE SELECT | STEP MODE
Press Pattern Page button 1-8, 9-16, 17-24, or 25-32. If the
sequencer is running, selecting a page pauses the chasing
behavior of OCTAVE / LOCATION LEDs 1-4, and the Step buttons
address only steps on the selected page. To resume the LED
chasing behavior, press the currently selected Page button again.
ENABLE/DISABLE STEPS | STEP MODE
Press any Step button 1-8 to toggle
steps On/Off. The state of each step is
indicated by Step LEDs 1-8. If a step is
Off, Octave/Location LED 8 will be lit
yellow to indicate the step contains a Rest.
SET END | STEP MODE
Press SET END followed by
a Step button corresponding
to the desired last step.
If the new end step is after
the previous end step, the notes are lled as follows: If the steps after the previous end step have never
been edited and stored in memory, or if the pattern was initialized, then all steps get the default note
value (-1V) and gate length (50%). If the steps were previously edited then they are restored.
ROTATE SEQUENCE | STEP MODE
Press the RIGHT arrow to move all steps right by one step.
Press the LEFT arrow to move all the steps left by one step.
+
Specify Last Step In Current Pattern
Select Page Of End Step Set End Step
+
Select Pattern Page / Activate LED Chasing
Enable/Disable Steps
+
Specify Last Step In Current Pattern
Rotate The Pattern Steps