Moog Mother-32 - Patchbay Inputs and Outputs (continued); Voltage Controlled Oscillator (continued); Low Frequency Oscillator

41
PATCHBAY INPUTS AND OUTPUTS (continued)
VOLTAGE CONTROLLED OSCILLATOR (continued)
VCO LIN FM INPUT
This is a Linear Frequency Modulation input, which is useful for modulating
the VCO with audio rate waveforms to achieve very harmonically rich sounds.
(Accepts a -5 to +5V signal).
VCO MOD INPUT
This input is routed to the UP position of the VCO MOD SOURCE selector
switch (EG/VCO MOD).
NOTE: When a cable is plugged into the VCO MOD input, it overrides the normalization
of the EG to the UP position of the VCO MOD SOURCE switch. This allows the VCO
MOD AMOUNT control to function as an attenuator for anything plugged into the
VCO MOD input prior to being sent to a selected VCO Mod Destination.
VCO SAW OUTPUT
This output is the VCO Sawtooth waveform (+/-5V).
VCO PULSE OUTPUT
This output is the VCO Pulse waveform (+/-5V).
LOW FREQUENCY OSCILLATOR
LFO RATE INPUT
This input is summed with the LFO RATE panel control. With the RATE control
at center position, a -5V to +5V control voltage at this input will sweep the LFO
Rate from roughly .18Hz to 190Hz. Maximum LFO rate is about 600Hz.