43
PATCHBAY INPUTS AND OUTPUTS (continued)
VC MIX - VOLTAGE CONTROLLED, DC COUPLED MIXER (continued)
VC MIX OUTPUT
This is the output of the VC Mixer which is a blend of the MIX 1 and MIX 2 input
signals set by the VC MIX panel control and VC MIX CTRL CV input. (+/-5V).
VC MIX ALTERNATE USES:
FIXED VOLTAGE SOURCE
With nothing plugged into the MIX 1 or MIX 2 inputs, the VC MIX control
allows the VC MIX output to transmit a variable xed voltage from 0 to +5V.
ATTENUATOR
Apply a CV signal to be attenuated to the MIX 2 input. With the VC MIX control at full counterclockwise
position, the signal is fully attenuated. Turn the VC MIX control clockwise to increase the amount of
MIX 2 input signal passed to the VC MIX output.
VCA
Apply a CV signal to the MIX 2 input. With the VC MIX control at a fully counterclockwise position,
apply a 0V to positive CV signal to the VC MIX CTRL input (EG for example). This will dynamically
determine the amplitude of the signal at the MIX 2 input that is passed to the VC MIX output.
MULTIPLE
The MULT section of the patchbay is a signal splitter that allows you to take a single voltage source
and send it to two independent locations.
MULT INPUT
Buffered signal input.
MULT 1 OUTPUT
Buffered Output 1 of the MULT input.
MULT 2 OUTPUT
Buffered Output 2 of the MULT input.
WARNING: Do not use the Mult to mix two signals together. It is designed to
be used ONLY as a CV signal splitter.
To Next Page
Loading...
