Moog Mother-32 - Saving a Pattern; Select Bank; Complete or Cancel Save; Restore a Pattern from Memory

26
SAVING A PATTERN
Any changes to the current pattern are
discarded when changing to a new pattern
unless they are saved.
To Save a pattern, hold (SHIFT)+RUN/STOP
for one second. An Octave/Location LED
will rapidly blink green indicating the current
destination for saving.
To Save in the current location, simply press
(SHIFT)+RUN/STOP.
To Save in a new location within the current bank, use the LEFT/RIGHT arrows to select Pattern location 1-8.
NOTE: You can also hold (SHIFT) and press one of the eight corresponding pattern location buttons.
SELECT BANK
To Save a pattern in a different bank (1-8), press
and hold (BANK). The current bank will be lit green.
While holding (BANK), use the LEF T/RIGHT arrows
to select a new bank. When (BANK) is released,
the current pattern location will be indicated with a
green blinking LED.
NOTE: You can also hold (BANK) and press one
of the eight corresponding pattern location buttons.
COMPLETE OR CANCEL SAVE
To complete the saving process press (SHIFT)+RUN/STOP.
To exit the saving process at any time, simply press RUN/STOP.
RESTORE A PATTERN FROM MEMORY
Once a pattern has been modied, it can be returned to its
original state by pressing PATTERN+RESET. This will restore
the current pattern from memory and any unsaved changes
will be discarded.
Select Pattern Location
Blinking Green LED
Indicates Save Destination
+
+
Select Bank Location
Green LED Indicates
Save Destination Bank
+
+
+