Moog Mother-32 - Patchbay Inputs and Outputs (continued); Assignable Output

44
PATCHBAY INPUTS AND OUTPUTS (continued)
ASSIGNABLE OUTPUT
ASSIGN OUTPUT
This is the output for the assignable jack. Its source is programmed in
Setup mode. To learn more about Setup mode, go to Page 49.
The following output sources are available:
1: ACCENT (Default) This outputs a 0 to +5V ltered pulse signal from Accented pattern steps only.
2: CLOCK This outputs a 0 to +5V Clock signal at the internal clock tempo, one pulse per step.
3: CLOCK/2 This outputs a 0 to +5V Clock signal at half the clock rate of the internal clock tempo.
4: CLOCK/4 This outputs a 0 to +5V Clock signal at one quarter of the clock rate of the internal clock tempo.
5: STEP RAMP This outputs a -5 to +5V Ramp wave that increases in value equally across the number
of steps in the current pattern. The wave is reset at minimum when the sequencer cycles to step 1.
6: STEP SAW This outputs a -5 to +5V Saw wave that decreases in value equally across the number of
steps in the current pattern. The wave is reset at maximum when the sequencer cycles to step 1.
7: STEP TRIANGLE This outputs a -5 to +5V Triangle wave that alternates every pattern run between
an increase in value equally across the number of steps in the current pattern, and a decrease in value
equally across the number of steps in the current pattern.
8: STEP RANDOM This outputs a random voltage between -5V and +5V per step while the sequencer
is running.
9: STEP 1 TRIGGER This outputs a 0 to +5V pulse output only on step 1 of the current pattern.
10: MIDI VELOCITY This outputs a -5V to +5V signal from MIDI Note On Velocity values 0 to 127.
11: MIDI CHANNEL PRESSURE This outputs a -5V to +5V signal from MIDI Channel Aftertouch values 0 to 127.
12: MIDI PITCH BEND This outputs a -5V to +5V signal from MIDI Pitch Bend values 0 to 127.
13: MIDI CC 1 This outputs a -5V to +5V signal from MIDI CC 1 values 0 to 127.
14: MIDI CC 2 This outputs a -5V to +5V signal from MIDI CC 2 values 0 to 127.
15: MIDI CC 4 This outputs a -5V to +5V signal from MIDI CC 4 values 0 to 127.
16: MIDI CC 7 This outputs a -5V to +5V signal from MIDI CC 7 values 0 to 127.