35
SEQUENCER PANEL FUNCTION QUICK REFERENCE (continued)
KB MODE PANEL FUNCTIONS (continued)
GATE LENGTH | STEP MODE
Rotate the GATE LENGTH control to modify the Gate Length of a currently
selected step. Maximum Gate Length ties the selected step to the next step.
ACCENT | KB MODE
Press ACCENT to add an Accent to the current step.
Octave/Location LED 7 is green when Accent is On.
REST | KB MODE
Press REST to add a Rest to the current step and advance to edit the next step.
Octave/Location LED 8 is green when Rest is On.
GLIDE ON/OFF | KB MODE
Rotate the GLIDE control right to turn Glide ON for a step. Rotate the
GLIDE control fully counterclockwise to turn Glide OFF for that step.
Octave/Location LED 5 is green when Glide is On.
RATCHET | KB MODE
While holding (SHIFT), rotate the GLIDE control to select a value of 1-4.
The Ratchet value is shown in yellow on the Octave/Location LEDs
1-4, indicating the number of notes per step. Octave/Location LED 6 is
green when a Ratchet value is set from 2 to 4.
PATTERN PAGE SELECT | KB MODE
Press (SHIFT)+Page button 1-8, 9-16, 17-24 or 25-
32. If the sequencer is running, this will pause the
page chasing behavior. Press (SHIFT)+ the currently
selected Page button to resume page chasing.
STEP SELECT AND
EDIT | KB MODE
Press (SHIFT)+Step button
1-8. If in the Record function,
this stops the Step-Write
behavior so that any step
can be selected for editing. When a step is selected and the sequencer is stopped, the current note
value is played so its pitch can be monitored prior to editing.
+
+
Select Pattern Page
Select Step For Editing
+
To Next Page
Loading...
