28
STEP MODE TUTORIAL - CREATING A PATTERN (continued)
SETTING PATTERN LENGTH
You can create a pattern with up to 32 steps, however, in this case we are going to set the pattern
length to be eight steps.
Press SET END and then press Step 8. All eight Step LEDs are now lit solid and blink only when the
pattern advances through them. All notes are currently the same, so you need to edit each step to
make the pattern more interesting.
ENTERING RESTS ON STEP 5 & 8
Press the Step 5 and Step 8 buttons. Step LEDs 5 and 8 are now turned OFF, and there are Rests when
the sequencer advances through these steps.
EDITING STEP 2
Press (SHIFT)+Step 2. The Tempo LED blinks alternating yellow and red at the clock rate to indicate
that a step is being edited. Step LED 2 will blink rapidly indicating that it is selected for editing. A red
Octave/Location LED is lit, indicating the current Keyboard octave and that the Keyboard is now ready
to change the current step’s note value.
Enter Rest Enter Rest
+
LED Will Blink Rapidly To Indicate Step Is Selected For Editing
Select Step To Edit
Select End Step
Set End Step
To Next Page
Loading...
