Motion 3000ES Escalator Control
6 Manual # 42-02-E001
Controller Parameters
A simple keypad and display allow access to controller parameters.
• ESC button: Press to exit parameter settings without saving changes.
• UP button: Move up in parameter settings list. Change the value of a selected digit. (Digit
will be flashing when its value can be changed.)
• DOWN button: Move down in parameter settings list. Move between digits of a selected
value.
•OK: Select/Save.
• At the highest level, parameters are grouped under seven functions, FUN1 through FUN7.
•Within each function, parameters are listed numerically by function and parameter order
(i.e., F1-01 is the first parameter of function FUN1, F1-02 is the second, etc.).
• Consult the complete parameter table for an ordered list of all parameters. Please refer to
“Controller Parameters” on page 32.
• To reset any latched fault, press both UP and DOWN buttons and hold them down for two
seconds.
Your controller may have
the optional LCD display.
The LCD display is capable
of displaying full text status
and error messages.
To Next Page
Loading...