MOTO GUZZI GRISO Use And Maintenance Book

use and maintenance Griso R
40
CONTROLS ON RIGHT HANDLEBAR
NOTE The electric components only operate when the ignition
switch is in the “ ” position.
7) ENGINE STOP SWITCH ( - )
8) STARTER BUTTON ( )
When the starter button " " is pressed, the starter motor will
crank the engine. See page 63 (STARTING) for the starting
procedure.
WARNING
Do not operate the engine stop switch " - " while riding.
This switch serves as a safety or emergency switch. With the
switch pressed in position “ ”, it is possible to start the
engine; the engine can be stopped by pressing the switch to
position “ ”.
CAUTION
With the engine stopped and the ignition switch in position
" ", the battery may run flat. When the vehicle has come to a
standstill and you have stopped the engine, set the ignition
switch to position " ".
7
8
GUZum_griso1100#06_#USA.book Page 40 Tuesday, March 21, 2006 2:43 PM

MOTO GUZZI GRISO Specifications

General

Cooling System	Air-cooled
Final Drive	Shaft drive
Seat Height	800 mm
Engine Type	90° V-twin
Fuel System	Electronic fuel injection
Front Suspension	43mm upside-down fork
Front Brakes	Dual 320mm discs, 4-piston calipers
Frame	Tubular steel