MOTO GUZZI GRISO Use And Maintenance Book

43
use and maintenance Griso R
AUXILIARY EQUIPMENT
UNLOCKING/LOCKING THE SEAT
u Place the vehicle on the stand, see page
50 (PUTTING THE VEHICLE ON THE
STAND).
u Insert the key (1) into the seat lock.
u Turn the key (1) clockwise and push
softly onto the rear seat middle to
facilitate pin release, then lift and slide
out the seat (2) from behind.
NOTE Before lowering and locking the
seat (2), make sure that you have not left
the key in the tool kit compartment.
To lock the seat (2):
u Slide the seat front end into place.
u Lower the rear end and position the seat
so that the two hooks (4) are correctly
hooked to the frame fasteners.
u Push down on the middle of the rear end
until the lock clicks shut.
WARNING
Before riding, make sure that the seat
(2) is properly locked.
TOOL KIT COMPARTMENT
To gain access to the tool kit
compartment:
u Remove the seat, see
(UNLOCKING/LOCKING THE SEAT), in
this page.
u Remove the cover (3).
1
2
3
4
GUZum_griso1100#06_#USA.book Page 43 Tuesday, March 21, 2006 2:43 PM

MOTO GUZZI GRISO Specifications

General

Cooling System	Air-cooled
Final Drive	Shaft drive
Seat Height	800 mm
Engine Type	90° V-twin
Fuel System	Electronic fuel injection
Front Suspension	43mm upside-down fork
Front Brakes	Dual 320mm discs, 4-piston calipers
Frame	Tubular steel