MOTO GUZZI GRISO Use And Maintenance Book

use and maintenance Griso R
96
u Place the vehicle upright.
u Turn screw (2) to set headlight beam.
When finished:
WARNING
Make sure that the vertical adjustment
of the headlight beam is correct.
Different jurisdictions have different
requirements for horizontal headlight
beaming. Make sure that you comply
with the rules of the jurisdiction where
your vehicle is being used.
BULBS
Carefully read page 71
(MAINTENANCE).
WARNING
Do not use the vehicle if the lights are
not functioning properly.
Do not use the vehicle if the headlight is
adjusted incorrectly. This could
temporarily blind oncoming cars, and
also reduce the rider’s ability to see any
obstacle along the road while riding at
night.
It is always advisable to reduce speed
when riding at night, so as to have the
time necessary to avoid any obstacle
and to adapt to the poorer visibility that
inevitably results from darkness.
Failure to observe this warning can
cause you to collide with another
object, with consequent risk of serious
injury or even death.
WARNING
Fire hazard.
Keep fuel and other flammable
substances away from electric
components.
CAUTION
Before proceeding to change a bulb, set
the ignition switch to “ ” and allow
some time for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb. Do not put
your fingerprints on the bulb, as this
may lead to overheating and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
NOTE Before changing a bulb, check
the fuses, see page 93 (CHANGING THE
FUSES).
1
2
GUZum_griso1100#06_#USA.book Page 96 Tuesday, March 21, 2006 2:43 PM

MOTO GUZZI GRISO Specifications

General

Cooling System	Air-cooled
Final Drive	Shaft drive
Seat Height	800 mm
Engine Type	90° V-twin
Fuel System	Electronic fuel injection
Front Suspension	43mm upside-down fork
Front Brakes	Dual 320mm discs, 4-piston calipers
Frame	Tubular steel