MOTO GUZZI GRISO Use And Maintenance Book

75
use and maintenance Griso R
IDENTIFICATION DATA
It is a good rule to report the frame and
engine numbers in the space provided in
this manual.
The frame number must be quoted when
purchasing spare parts.
NOTE Altering a vehicle identification
numbers is illegal and punished by law with
fines and imprisonment. In addition,
altering the frame number invalidates the
warranty.
FRAME NUMBER
The frame number (1) is stamped on the
right side of the steering tube.
Frame no. ________________________
ENGINE NUMBER
The engine number (2) is stamped on the
left side close to the oil level plug/dipstick.
Engine no. ________________________
JOINTS WITH SCREW CLAMPS
CAUTION
Remove ONLY the clamps indicated in
the maintenance procedures.
This text is not to be intended as an
authorisation to arbitrarily remove the
clamps present on the vehicle.
WARNING
Before removing a clamp, determine
whether removal may lead to leakage
and, if so, take adequate measures to
prevent leakage and protect the
components positioned near the joint.
SCREW CLAMPS
For removal and installation it is sufficient
to use a common screwdriver.
CAUTION
Check the conditions of the clamp and
if necessary replace it with a new one of
the same type and dimensions,
available on request from Moto Guzzi
Authorized Dealers.
When tightening the clamp, make sure
that the joint is sufficiently stable.
1
2
GUZum_griso1100#06_#USA.book Page 75 Tuesday, March 21, 2006 2:43 PM

MOTO GUZZI GRISO Specifications

General

Cooling System	Air-cooled
Final Drive	Shaft drive
Seat Height	800 mm
Engine Type	90° V-twin
Fuel System	Electronic fuel injection
Front Suspension	43mm upside-down fork
Front Brakes	Dual 320mm discs, 4-piston calipers
Frame	Tubular steel