MOTO GUZZI GRISO Use And Maintenance Book

use and maintenance Griso R
90
u Make sure that the cable terminals and
the battery terminals are:
– in good condition (and not corroded or
covered with deposits);
– covered with neutral grease or Vaseline.
If necessary:
u Remove the battery, see (REMOVING
THE BATTERY), in this page.
u Clean off cable and battery terminals
with a wire brush to remove all traces of
corrosion.
u Install the battery, see page 92
(INSTALLING THE BATTERY).
REMOVING THE BATTERY
CAUTION
Removing the battery resets the
following functions: digital clock, trip
info and lap times. To reset these
functions, see page 33
(MULTIFUNCTION COMPUTER).
Carefully read page 8 9 (BATTERY).
u Make sure that the ignition switch is in
position " ".
u Remove the rider seat, see page 43
(UNLOCKING/LOCKING THE SEAT).
u Loosen the two screws (1) and move
aside the cover (2).
1
2
GUZum_griso1100#06_#USA.book Page 90 Tuesday, March 21, 2006 2:43 PM

MOTO GUZZI GRISO Specifications

General

Cooling System	Air-cooled
Final Drive	Shaft drive
Seat Height	800 mm
Engine Type	90° V-twin
Fuel System	Electronic fuel injection
Front Suspension	43mm upside-down fork
Front Brakes	Dual 320mm discs, 4-piston calipers
Frame	Tubular steel