MOTO GUZZI GRISO Use And Maintenance Book

use and maintenance Griso R
98
CHANGING THE FRONT AND REAR
TURN INDICATOR BULBS
Carefully read page 96 (BULBS).
u Place the vehicle on the stand, see page
70 (PUTTING THE VEHICLE ON THE
STAND).
u Unscrew and remove the screw (1).
CAUTION
While removing the lens, proceed
carefully in order not to break the
locating peg.
u Remove the lens (2).
CAUTION
Make sure that the lens locates
correctly into its seat on refitting.
Tighten the screw (1) moderately and
carefully, to avoid damaging the lens.
u Press the bulb (3) slightly and rotate it
anticlockwise.
u Extract the bulb (3) from its seat.
CAUTION
Insert the bulb into the bulb holder, so
that the two pins slide into the slots in
the holder.
u Fit a new bulb of equal rating.
CAUTION
If the bulb holder (4) comes off, refit it
into its seat so that the chamfered
opening of the holder matches the hole
for the screw.
CHANGING THE TAIL LIGHT BULB
This vehicle fits a LED tail light, have it
replaced by a Moto Guzzi Authorized
Dealer.
REPLACING THE NUMBER PLATE
BULB
Since this operation is quite complex, have
it performed by a Moto Guzzi Authorized
Dealer.
2
43
1
GUZum_griso1100#06_#USA.book Page 98 Tuesday, March 21, 2006 2:43 PM

MOTO GUZZI GRISO Specifications

General

Cooling System	Air-cooled
Final Drive	Shaft drive
Seat Height	800 mm
Engine Type	90° V-twin
Fuel System	Electronic fuel injection
Front Suspension	43mm upside-down fork
Front Brakes	Dual 320mm discs, 4-piston calipers
Frame	Tubular steel