NEXT > < PREV CONTENTS
ADVANCED FEATURES
Channel Change On/Off Hook
This feature determines the mode of the radio based on the Hub on/off-hook state of all the control heads.
Whenever the radio goes off-hook, it changes to a preprogrammed zone channel assigned for off-hook state.
While in off-hook state, you can change the mode manually. When you return the radio to onhook state, it
reverts to its previous channel zone before the radio goes off-hook.
Note: If the radio is operating on Tone Private Line (PL) Defeat or Suspend Scan operations during on-hook
state, the radio is converted to work in a new channel and the Channel Change on Off-Hook feature is
suspended until these conditions end.
During Dynamic Regroup channel selector lock state, Emergency, Transmit Inhibit, radio lock, or when an
external key loader is attached to the radio, the Channel Change on Off-Hook feature is suspended until the
following conditions end.
233
To Next Page
Loading...
