NEXT > < PREV CONTENTS
ADVANCED FEATURES
(continued)
234
The Off Hook State for APX Dual-Radio Setup
For Dual-Radio, the state of the Hub on the unselected radio is always considered as on-hook. When the Hub
is in off-hook state, the selected radio changes the channel according to the configuration of the Customer
Programming Software (CPS), and the unselected radio does not trigger a channel change.
With Channel Change on Off-Hook enabled, when the Hub is placed off-hook and radio switch happens, the
new selected radio moves to the target channel zone of its off-hook state. The new unselected radio reverts to
the last user selected channel before the off-hook state.
The Off-Hook State for Multiple Radios Setup
When multiple control heads are connected, the states of these Hubs reflect the state of the active control
head(s). Any Hub placed off-hook by the active control head(s) makes the radio goes into off-hook state. The
radio can be in on-hook state only when all Hubs are placed on-hook.
Note: Familiarize yourself with the functionality of this feature as removing the microphone easily triggers a
mode change on the radio.
To Next Page
Loading...
