4 - 6 MC9090-G RFID Integrator Guide Supplement
Tag Logging
If Tag Logging is configured, all tags will be forwarded to the serial port, or to an IP address/port.
•
Address:
This can be an IP address, or COM port. If it is a COMPORT, enter "COM1:", etc… (a Bluetooth COM port
can be configured here as well).
•
Port:
The IP Port number or the COMPORT (i.e. if Address is COM1:, put 1 here).
•
Speed:
This is only used for the COM port. Can be up to 115200.
•
Log To File:
Check this box to save all logging to a file. If an external location is not specified the log file is saved in a file
named Taglog.txt on the reader root directory.
Registry Settings Description
The RFIDDemo registry file restores the demo settings after a cold boot (see Performing a Cold Boot on page 1-9).
If this file is edited, the settings will not be implemented until a cold boot occurs. Alternatively, on some Motorola
devices, the registry file can be launched. When this is done, a prompt appears asking the user to choose whether
to merge these settings into the registry. The next time the demo is launched, it will use the settings in this file. Do
not perform this function while the demo is running. The Gemini_RFID.exe demo also uses many of these registry
settings and can be used to registry settings. Do not launch the Gemini_RFID.exe demo while the RFIDDemo is
running. Table 4-1 on page 4-7 provides the RFIDDemo registry file example.
NOTE The comport is currently configured for 8 bits, no parity, 1 stop bit.
NOTE All DWORD values must be in hex notation.
To Next Page
Loading...
