Chapter 6 SymbolRoam
Introduction
The SymbolRoam application is provided to allow users change operating regions.
'The SymbolRoam application is run on boot-up each time the unit is re-started.
To run the application manually, run SymbolROAM.exe from the path \Application\ROAM on the device.'
NOTE The SymbolRoam application is not provided on the EU configuration. The EU configuration is
pre-set to comply with the EU regulatory specifications.
NOTE The screens and windows are provided for illustration purposes only and may differ from actual screens.
The applications described may not be available on (or applicable to) all devices.
Procedures are not device specific and are intended to provide a functional overview.
To Next Page
Loading...
