8 - 8 MX101 PRODUCT REFERENCE GUIDE
7. Connect the cable to the micro USB port on the bottom of the scan module. Ensure the cable is clipped
into the scan module plastic directly below the USB port.
8. Slide the CSS tower cover back into place. Ensure the cable service loop folds up into the blank space in
the CSS tower cover, on the opposite side of the scan module. Snaps should click together. When the
tower cover is replaced, the module locks into the grommet compression ribs on the MP6000.
9. Replace MP6000 tower bezel. Snap down into place.
To Next Page
Loading...
