CHAPTER 4 USER PREFERENCES &
MISCELLANEOUS OPTIONS
Introduction
You can program the digital scanner to perform various functions, or activate different features. This chapter
describes each user preference feature and provides programming bar codes for selecting these features.
The digital scanner ships with the settings shown in Table 4-1 on page 4-2 (also see Appendix A, Standard
Default Parameters for all host device and miscellaneous defaults). If the default values suit requirements,
programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when the digital scanner is powered down.
To return all features to default values, scan the *Restore Defaults on page 4-4. Throughout the programming
bar code menus, asterisks indicate (
*) default values.
Phantom Scan Session
The Phantom Scan Session feature places the system into a known state for two seconds immediately after
the power-up beep sequence in order to decode a parameter bar code without intervention, and regardless of
existing settings and mode. This allows the user to scan a Set Defaults, or other parameter bar code without
triggering the decoder or initiating a host scan session in order to return an unresponsive system to its factory
default settings. Aim and illumination are turned off, and Phantom Scan exits upon a host command or
successful decode.
*High Volume
(00h)
Feature/Option
* Indicates Default
Option Hex Value
To Next Page
Loading...
