4 - 2 MX101 PRODUCT REFERENCE GUIDE
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under Beeper Tone on page 4-8. The scanner issues
a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Data Transmission Formats, require scanning several bar codes. See these
parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences Parameter Defaults
Table 4-1 lists defaults for user preferences parameters. To change any parameter value, scan the appropriate
bar code(s) provided in the User Preferences section beginning on page 4-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 4-1
User Preferences Default Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults
4-4
Parameter Bar Code Scanning ECh Enable
4-5
Lock Parameter Scanning F2h 22h Disable
4-6
Unlock Parameter Scanning F2h 23h Disable
4-6
Beep After Good Decode 38h Enable
4-7
Beeper Tone 91h Medium
4-8
Beeper Volume 8Ch High
4-9
Beeper Duration F1h 74h Medium
4-10
Suppress Power-up Beeps F1h D1h Do not suppress
4-10
Trigger Modes 8Ah Presentation Mode
4-11
Decode Session Timeout 88h 9.9 Sec
4-11
Timeout Between Decodes, Same Symbol 89h 0.3 Sec
4-12
Timeout Between Decodes, Different Symbols 90h 0.2 Sec
4-12
Motion Detect Range F2h 3Bh Full
4-13
To Next Page
Loading...
