Motorola WT4090 - Regulatory Options

5 - 34 WT4070/90 Wearable Terminal Integrator Guide
The AP Networks and Ad-Hoc Networks check boxes are selected by default. To select/de-select the checkboxes,
press
TAB to highlight a checkbox. Press Blue - BKSP to select or de-select the checkbox.
Press
TAB to highlight Save and then press ENTER to save the settings or press ESC to discard any changes.
Press
ESC to exit the Options dialog box.
Regulatory Options
Use the Regulatory settings to configure the country the wearable terminal is in. Due to regulatory requirements
(within a country) a wearable terminal is only allowed to use certain channels.
Figure 5-44 Regulatory Options Dialog Box
1. Press TAB to highlight the Settings drop-down menu. Use the scroll keys to select a country from the list.
2. Press TAB to highlight the Enable 802.11d checkbox. Press Blue - BKSP to enable or disable the check box.
3. Press TAB to highlight Save and then press ENTER to save the settings or press ESC to discard any changes.
4. Press ESC to exit the Options dialog box.
Table 5-23 OP Mode Filtering Options
Field Description
AP Networks Select the AP Networks check box to display available AP networks and their signal
strength within the
Available WLAN Networks (see Find WLANs Application on page
4-5). These are the APs available to the wearable terminal profile for association. If
this option was previously disabled, refresh the
Available WLAN Networks window to
display the AP networks available to the wearable terminal.
AD-Hoc Networks Select the
Ad-Hoc Networks check box to display available peer (adapter) networks
and their signal strength within the
Available WLAN Networks. These are peer
networks available to the wearable terminal profile for association. If this option was
previously disabled, refresh the
Available WLAN Networks window to display the Ad
Hoc networks available to the wearable terminal.
Table 5-24 Regulatory Options
Field Description
Settings Select the country from the drop-down list. To connect to a profile, the profile country must
match this setting, or the AP country setting if you select the
Enable 802.11d check box.
Enable 802.11d If you enable this setting the WLAN adapter attempts to retrieve the country setting from
the APs. Profiles which use Infrastructure mode can only connect if this country setting is
the same as the AP country setting or if the profile country setting is set to
Allow Any
Country
. All APs must be configured to transmit the country information.