Accessories 2 - 11
Four Slot Spare Battery Charger
This section describes how to set up and use the Four Slot Spare Battery Charger to charge up to four spare
batteries.
Figure 2-9
Four Slot Spare Battery Charger Setup
Spare Battery Charging
1. Connect the charger to a power source.
2. Insert the battery into a spare battery charging slot and press down on the battery to ensure proper contact.
Figure 2-10
Spare Battery Charging
CAUTION Ensure that you follow the guidelines for battery safety described in Battery Safety Guidelines on page
10-3.
CAUTION Use only an approved power supply output rated 12 VDC and minimum 3.3 A. Use of an alternative power
supply will void the product warranty and may cause product damage. Refer to the WT4070/90 User Guide
for the power supply regulatory compliance statement.
Spare Battery Charge
Status LEDs (4)
Spare Battery Charging Well (4)
To Next Page
Loading...
