10 - 2 WT4070/90 Wearable Terminal Integrator Guide
•
Regularly replace all Velcro
®
straps on the wrist mount and wearable scanners, to ensure adequate
adhesion of the Velcro.
•
On touch screen versions, periodically replace the screen protector, especially if it is scratched.
Wrist Mount Cleaning Instructions
It may be necessary to wash the wrist mount straps and replaceable pad when they become soiled.
Remove the straps and pad from the wrist mount. Hand wash in cold water with a mild detergent (such as
Woolite
®
). Do not use bleach. Air dry. Do not use a dryer.
Figure 10-1
Wrist Mount Soft Goods
Arm Sleeve Cleaning Instructions
It may be necessary to wash the arm sleeve when it become soiled.
Hand wash in cold water with a mild detergent (such as Woolite®). Do not use bleach. Air dry. Do not use a dryer.
Removing the Screen Protector
A screen protector is applied to the wearable terminal with touch screen. Zebra mandates using this to minimize
wear and tear. Screen protectors enhance the usability and durability of touch screen displays.
To remove the screen protector, lift the corner using a thin plastic card, such as a credit card, then carefully lift it off
the display.
NOTE Not using a screen protector on a touch panel device can affect warranty coverage. To purchase replacement
protectors, contact your local account manager or Zebra. These include screen protector installation
instructions. Part number: KT-67525-01R or KT-67525-02R Screen Protector 3/pk.
To Next Page
Loading...
