Accessories 2 - 13
Wall Mount Bracket
Use the wall mounting bracket to mount a Four Slot Ethernet cradle and a Four Slot Battery Charge together on a
wall.
To mark the screw holes for mounting the bracket use the wall mounting bracket as a template. Place the bracket
onto the wall, level and mark the five screw hole locations.
1. Install top three screws into the wall.
2. Align the top three mounting holes with the screws.
3. Place mounting bracket on screws.
4. Secure the mounting bracket to the wall by tightening the three screws.
5. Install and secure two screws at the bottom of the bracket.
Figure 2-11
Mounting the Bracket
Right Cable Slot
Left Cable Slot
Power Supply Mounting Shelf
Charger Mounting Studs
Cradle Alignment Tab
To Next Page
Loading...
