53
Bypass mode
The inverter is working without DC/INV operation and connecting to the loads.
Only utility is charging battery and
providing power to connected loads.
Only utility is available to provide
power to connected loads.
Standby mode :
The inverter is working without DC/INV operation and load connected.
This inverter is disabled on AC output
or even AC power output is enabled,
but an error occurs on AC output.
Only PV power is sufficient to charge
battery.
This inverter is disabled to generate
power to the loads via AC output. PV
power is not detected or available at
this moment. Only utility is available
to charge battery.
To Next Page
Loading...
Need help?
General