MR TAPCON 230 Expert - Page 37

6 Mounting
Maschinenfabrik Reinhausen GmbH 2021 377817454/02 EN TAPCON
®
230 Expert
Dimensions for the control panel cutout
B: 202mm (7.95in)
A: 312mm (12.28in)
t = 2...5mm (0.08...0.2in)
Figure17: Dimensions for the cutout
1. Cut out the section for the control panel.
A
B
Figure18: Cutting out the section for the control panel
2. Slide the device into the cutout from the front and insert tension clamps.
Figure19: Inserting the device into the cutout