MR TAPCON 230 Expert - Page 73

9 Operation
Maschinenfabrik Reinhausen GmbH 2021 737817454/02 EN TAPCON
®
230 Expert
Activate syslog
You can use this parameter to activate transmission of syslog messages via
the device.
Syslog standard
You can use this parameter to adjust the transmission process and the for-
mat for the syslog messages. You can select the following options:
Standard Transport Message format
RFC5425 (recom-
mended)
TLS RFC5424
RFC5426 UDP
RFC6587 TCP
RFC3164 UDP RFC3164
Table16: Syslog standard
If you use the standard RFC5245 (TLS), you have to import the root certifi-
cate and the client certificate with the corresponding key to the syslog
server. For more information, refer to the section titled Importing data.
Syslog server
You can use this parameter to set the IP address of the syslog server.
Syslog server port
You can use this parameter to set the port of the syslog server.
Reconnect delay time
You can use this parameter to determine how long the device will wait be-
fore it attempts to reconnect after the connection has been interrupted earlier
or a syslog message could not be transmitted (only for TCP or TLS).
Device designation
You can use this parameter to set the device designation that the device will
be identified with on the syslog server.