MSA ORION - Toxic Gas Measurements (FIGURE 3-8); Warning

º
WARNING
If the Oxygen alarm condition is reached while using the
instrument as a personal or area monitor, leave the area
immediately; the ambient condition has reached a preset
alarm level. If using the instrument as an inspection device,
do not enter the area without proper protection. Failure
to follow this warning will cause exposure to a hazardous
environment which can result in serious personal injury
or death.
Toxic Gas Measurements (FIGURE 3-8)
•
The Orion Multigas
Detector can be
equipped to detect:
•
Carbon
Monoxide
(CO) and/or
•
Hydrogen
Sulfide (H
2
S)
in the
atmosphere.
•
When the alarm
setpoint is reached
for Carbon
Monoxide (CO)
and/or Hydrogen
Sulfide (H
2
S):
•
Alarm Sounds
•
Alarm Lights flash
•
PPM CO or PPM H
2
S label above the concentration flashes.
º
WARNING
If the Toxic Gas alarm condition is reached while using the
instrument as a personal or area monitor, leave the area
immediately; the ambient condition has reached a preset
alarm level. If using the instrument as an inspection device,
do not enter the area without proper protection. Failure to
follow this warning will cause over-exposure to toxic gases,
which can result in serious personal injury or death.
Figure 3-8. Instrument in Toxic Gas Alarm
Operating Manual Chapter 3, Using the Orion Multigas Detector
3-11