EasyManuals Logo

MST ImPact WAP User Manual

MST ImPact WAP
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
If the Access Point is sending tag reports to an MST Tracker Engine, the Tracker Engine's IP address
must be entered into each Access Point.
There are four sections on the Tracking conguration screen:
Enable
Check Enable Wi-Fi Tracking to view other settings.
RSSI Lower Thresholds
These settings are used to control what location reports are sent to the Positioning Engine. If a Wi-Fi tag
or mobile unit report is received with an RSSI below the relevant threshold, it is not sent to the Positioning
Engine (whether it is an AeroScout Positioning Engine or MST Tracker Engine). The default threshold
is -95 dBm, but this can be raised or lowered according to specic site conditions and requirements.
Revision B50Wireless Access Point User Manual
Conguration Using the Web Interface

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MST ImPact WAP and is the answer not in the manual?

MST ImPact WAP Specifications

General IconGeneral
BrandMST
ModelImPact WAP
CategoryWireless Access Point
LanguageEnglish