• Parameter Value: To edit a parameter, click on the parameter value and either enter a new value (e.g.
names and IP addresses) or select a new value from the dropdown menu (e.g. ENABLED / DISABLED).
When all required changes have been made, click OK to close the dialog box. The Managed status of
all available parameters can be changed at once using the Manage All and Manage None checkboxes
below the list.
4.1.3 Access Point
Access Points (APs) become visible to the ICA after the map containing them is rst synchronised from
AeroScout. Once visible, APs are automatically added to the List of Access Points
Revision B58Wireless Access Point User Manual
Centralised Conguration Management
To Next Page
Loading...