2.5 Ethernet Cable
The WAP3 is typically powered from an 802.3af (Mode A) Power over Ethernet (PoE) supply, which
sends power down the Ethernet cable. The WAP3 is normally connected and powered via an M12-to-RJ45
Ethernet cable from the WAP3's Ethernet port to an MST Wireless Network Switch (WNS, NS50), but
can also be powered by a separate PoE power supply. The Ethernet cable is required to meet specications
for use in a mining environment as described in Ethernet Cable Specications on page 67.
Revision B20Wireless Access Point User Manual
Installation
To Next Page
Loading...