3.5 Settings Tab
3.5.1 Managing Automatic TFTP Configuration
The Cong Management screen is used to congure how the device retrieves its conguration from a
TFTP server on the network. For more information on TFTP, see Centralised Conguration Management
on page 55.
Note: These settings only affect TFTP conguration from a ICA v1.3.1 or earlier, and 3rd party
TFTP servers. If using AP Cong Templates from ICA 1.4.0 or later, leave Self check disabled
(See Device Management Overview on page 56).
Self Check Settings
To enable automatic conguration from a TFTP server, tick the Self check enabled checkbox, enter the
desired Self check interval and TFTP Server Address, then click the Save Settings button.
Change Numbers
The two change numbers shown here are timestamps (formatted as YYYYMMDDhhmmss) showing the
last time the device's settings were updated via TFTP. The Site Change Number refers to general site
settings applied to all devices, whereas the Device Change Number refers to specic settings applied to
this device.
3.5.2 Configuring SNMP Settings
The SNMP screen contains Simple Network Management Protocol settings. SNMP is a protocol used by
the ICA and 3rd party SNMP browsers to monitor the status of compatible devices on the network. At
present, the ICA is not affected by the settings below.
Revision B40Wireless Access Point User Manual
Conguration Using the Web Interface
To Next Page
Loading...
Need help?
General