Final steps
1. Clean mating faces on cylinder head and charge-air pipe.
2. Check gaskets for damage and replace as necessary.
3. Coat gaskets with assembly compound and place on cylinder head.
4. Install leak-off-fuel lines.
5. Install charge-air pipes.
6. Install Engine Control Unit (→ Page 219).
7. Open fuel supply line.
8. Vent fuel system (→ Page 136).
MS15054/03E 2018-07 | Fuel System | 135
TIM-ID: 0000050910 - 007
To Next Page
Loading...
Need help?
General