8.13 Oil Filtration / Cooling
8.13.1 Engine oil filter – Replacement
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
Filter wrench
F30379104 1
Engine oil
Oil filter
(→ Spare Parts Catalog)
WARNING
Oil is hot.
Oil can contain residue/substances which are harmful to health.
Risk of injury and poisoning!
• Allow the product to cool to below 50 °C before beginning work.
• Wear protective clothing, protective gloves and goggles/safety mask.
• Avoid contact with skin.
• Do not inhale oil vapor.
Replacing engine oil filter
1. Provide a suitable container to collect the oil.
2. Remove drain plug (2) and drain oil.
3. Close drain plug (2) again.
4. Remove oil filter (3) with filter wrench.
5. Clean sealing face on connecting piece (1).
6. Check sealing ring (arrowed) of new oil filter
and moisten with oil.
7. Screw on and tighten oil filter by hand.
8. Replace other oil filters in the same way.
Note: Note max. starter actuation times (see data
in technical sales documentation (TVU)).
9. After each oil change and filter replacement,
bar engine with starting equipment
(→ Page 110).
10. Check oil level (→ Page 166).
168 | Oil Filtration / Cooling | MS15054/03E 2018-07
TIM-ID: 0000053456 - 004