multicomp pro MP720025 User Manual

User Manual
121
Figure 7-9 Set the network parameters of the computer
(8) Set the network parameters of the Oscilloscope Software. Run the software on the
computer; choose the "Ports-settings" of the "Communications" menu item. Set
"Connect using" to LAN. Set IP and Port to the same value in the oscilloscope. If you
can get data normally, the connection is successful.
Figure 7-10 Set the network parameters of the Oscilloscope Software

multicomp pro MP720025 Specifications

General

Brand	multicomp pro
Model	MP720025
Category	Test Equipment
Language	English