48 Part Number 9294699 12/16/15
Maintenance Section 4
BLENDERS / DISPENSE AREA CLEANING & SANITIZING
Grate Removal / Blender Station Wash
n
Warning
The blender station contains sharp moving parts. Wear
gloves to protect hands.
Follow the on screen instructions:
• Put on gloves and safety glasses.*
1. Remove grate from blender station(s) by pulling up and out.
2. Remove the cup cover seal from the cup cover by
pushing on the front and pulling down.
3. Spray all surfaces inside of the blender station(s)
with cleaning solution, then scrub thoroughly with
approved cleaning brush.
4. Thoroughly wipe down all surfaces of blender station
with a clean towel.
• Press the Down Arrow.
5. Repeat for other side if applicable.
• Press the Down Arrow. The Slide Progress screen
will display while the blender(s) move into cleaning
position.
Blender Door Removal
1. Slightly open blender door.
2. Squeeze at bottom of door.
3. Tilt out and pull the door down and out.
4. Repeat for other door if applicable. Take them back the
three (3) compartment sink to wash, rinse and sanitize
• Press the Down Arrow to continue.
Blender Station Wash
1. Completely spray blender station with cleaning
solution, use cleaning brush to thoroughly scrub down
the entire area.
2. Using the approved cleaning brush, thoroughly scrub
down top of blender cap and arm.
3. Lift blender cap and thoroughly scrub top of blade
housing and bottom of blender cap.
4. Repeat on other side if applicable.
• Press the Down Arrow to continue.
Clean Blender Shaft Bushing
1. Follow the blender shaft up above the blender cap, use
fingers to pull the bushing out of the blender chamber.
2. Spray with cleaner and use a brush and/or clean cloth
to wipe.
3. Spray with sanitizer and push back up into place.
• Press the Down Arrow.
4. Thoroughly spray with sanitizer solution and use
approved cleaning brush to scrub entire blender
assembly.
5. Repeat for other side if applicable.
• Press the Down Arrow to continue.
To Next Page
Loading...
Need help?
General
