Part Number 9294699 12/16/15 65
Section 5 Troubleshooting
Procedure to Clear Blocked Line
NOTE: Verify product is available and properly connected
before performing this procedure.
1. Fill a squirt bottle with very warm water.
2. Remove product bin.
3. Connect squirt bottle with vinyl tubing to product tube
inlet.
4. Select the Inventory icon from the Main Menu.
5. Select the product with the blocked line.
6. Select the green check twice without following the
product replacement instructions.
7. Select PRIME FLAVOR.
8. Place a cup under dispenser.
9. Select HOLD TO PRIME icon while squeezing the squirt
bottle. Watch for product to enter the cup.
10. Repeat until valve clears, product and/or water enters
the cup.
11. Disconnect squirt bottle with vinyl tubing. Insert
product bin back into unit.
12. Select HOLD TO PRIME icon until only product flows
into cup.
13. Press the Green Check when finished to return to the
product Inventory screen.
14. Press the Back Arrow to return to the Main Menu.