MULTIQUIP Rammax RX1575 - Unit Pre-Check; Commissioning and Inspection

PAGE 50 — RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL S/N 3069933~ — REV. #0 (11/29/23)
UNIT PRE
-
CHECK
57RAMMAX 1575
2.7.1 Commissioning
Before putting the machine into operation, always read the operating manual and inspect the machine according to
the instructions below.
Inspection of the machine before putting into operation:
• Check the arm release to secure the joint when transporting or loading the machine.
• Check the battery level of the remote control.
• Check the function of the automatic pairing of the remote control with the control unit.
• Check the site with regard to avoiding interference from the electronic ballast (due to external lamps tted with uorescent tubes).
• Check the function of the near and remote shut-down of the machine.
• Check the tightness of the fuel tank and fuel circuit.
• Check the hydraulic circuit for leaks.
• Check the tightness of all screw connections.
Note
If the remote control does not work and all LED indicators are o, connect the transmitter to the machine via the spiral cable. The bat-
tery will recharge.
2.7 Machine control and use